DATA LIST
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Total Distance Traveled | Current total driving distance | 0 to 16777215 | Equivalent to the actual total driving distance | - |
| Total Distance Traveled - Unit | - | - | - | Cannot be used |
| +B Voltage | Battery voltage | 0 to 25.5 [V] or Unset | 11 to 14 V | - |
| Illumination Rate from Illuminance Sensor | Illuminance sensor (meter mirror sub-assembly) status | 0 to 65535 [lx] or Unset | Value is output according to ambient light level | 0 is displayed when there is no light. |
| Vehicle Speed Meter | Vehicle speed input value | 0 to 255 [km/h] or Unset | Almost the same as actual vehicle speed | - |
| Engine RPM | Engine speed | 0 to 12701 [r/min] or Unset | Almost the same as actual tachometer | - |
| Brightness Up Switch | Brightness up switch | OFF or ON | OFF: Switch released ON: Switch pushed |
This item can be inspected by adjusting a setting in the HUD settings of the settings tab displayed on the multi-information display. |
| Brightness Down Switch | Brightness down switch | OFF or ON | OFF: Switch released ON: Switch pushed |
This item can be inspected by adjusting a setting in the HUD settings of the settings tab displayed on the multi-information display. |
| Projection Position Up Switch | Projection position up switch | OFF or ON | OFF: Switch released ON: Switch pushed |
This item can be inspected by adjusting a setting in the HUD settings of the settings tab displayed on the multi-information display. |
| Projection Position Down Switch | Projection position down switch | OFF or ON | OFF: Switch released ON: Switch pushed |
This item can be inspected by adjusting a setting in the HUD settings of the settings tab displayed on the multi-information display. |
| Display Change Switch | Headup display system status | OFF or ON | OFF: Headup display system off ON: Headup display system on |
- |
| Display Angle | Display angle of headup display | -12.7 to 12.8 [deg] or Unset | Current display angle of headup display |
·
Approximately -12.7 deg: vehicle rear
·
Approximately - 0 deg: center
·
Approximately 12.8 deg: vehicle front |
| Ambient Temperature (Celsius) | Ambient temperature (celsius) | -40 to 87.1 [°C] or Unset | Actual ambient temperature displayed | - |
| Ambient Temperature (Fahrenheit) | Ambient temperature (fahrenheit) | -40 to 215 [F] or Unset | Actual ambient temperature displayed | - |
| Illumination Rate from Light Control Sensor | Automatic light control sensor input | 0 to 65535 [lx] or Unset | Value is output according to ambient light level | 0 is displayed when there is no light. |
| LDA System | Availability of lane departure alert system | With or Without | With: Vehicle equipped with lane departure alert system Without: Vehicle not equipped with lane departure alert system |
- |
| PCS System | Availability of pre-collision system | With or Without | With: Vehicle equipped with pre-collision system Without: Vehicle not equipped with pre-collision system |
- |
| ICS System | Availability of parking support brake system | With or Without | With: Vehicle equipped with parking support brake system Without: Vehicle not equipped with parking support brake system |
- |
| Radar Cruise System | Availability of dynamic radar cruise control system | With or Without | With: Vehicle equipped with dynamic radar cruise control system Without: Vehicle not equipped with dynamic radar cruise control system |
- |
| Road Sign Assist System | Availability of road sign assist system | With or Without | With: Vehicle equipped with road sign assist system Without: Vehicle not equipped with road sign assist system |
- |
| ITS System | - | - | - | Cannot be used |
| Navigation System | Availability of navigation system | With or Without | With: Vehicle equipped with navigation system Without: Vehicle not equipped with navigation system |
- |
| Master Caution Display Function | Headup display master caution display setting | OFF or ON | Current headup display master caution display setting displayed | - |
| Seat Switch Link Function | Headup display power seat switch link setting | OFF or ON | Current headup display power seat switch link setting displayed | - |
| ECO Drive Indicator Zone Display Function | Headup display ECO drive indicator display setting | OFF or ON | Current headup display ECO drive indicator display setting displayed | - |
| LVN System | Availability of leading vehicle notification system | With or Without | With: Vehicle equipped with leading vehicle notification system Without: Vehicle not equipped with leading vehicle notification system |
- |
| Driver Emergency Stop Assist System | - | - | - | Cannot be used |
ACTIVE TEST
Using the GTS, perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Color Test Screen (Black) | Displays each color on headup display | ON | - |
| Color Test Screen (White) | Displays each color on headup display | ON | - |
| Color Test Screen (Red) | Displays each color on headup display | ON | - |
| Color Test Screen (Green) | Displays each color on headup display | ON | - |
| Color Test Screen (Blue) | Displays each color on headup display | ON | - |
| Color Test Screen (Color Bars) | Displays each color on headup display | ON | - |
| Color Test Screen (Adjustment) | Displays each color on headup display | ON | - |
| Display Brightness | Changes the brightness of headup display | 0 to 100 [%] | - |
| Display Position | Move the position of headup display | Up (+3)/Up (+2)/Up (+1)/Center/Down (-1)/Down (-2)/Down (-3) | - |