| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | Note |
|---|---|---|---|---|---|
| C13B800 | Electric Parking Brake Actuator |
·
Diagnosis Condition: Electric parking brake operating
·
Malfunction Status: Repeated slipping is detected
·
Detection Time: - |
·
Parking brake actuator assembly
·
Rear brake |
DTC stored | An electric parking brake system malfunction is displayed on the multi-information display. |
Although DTC C13B800 may be stored after forcibly releasing the parking brake, this is not a malfunction.
To ensure that the electric parking brake does not operate, wait for 4 minutes or more with the ignition switch off, the driver door closed, and the brake pedal not depressed, then disconnect each connector, fuse and relay.
After replacing the No. 2 skid control ECU (brake actuator assembly), perform "Calibration".
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>UTILITY
When replacing the No. 2 skid control ECU (brake actuator assembly), operate the electric parking brake switch assembly as the parking brake indicator light blinks when the ignition switch is first turned ON.
Using the GTS, check for DTCs other than DTC C13B800.
| Result | Proceed to |
|---|---|
| Only DTC C13B800 is output | A |
| DTCs other than C13B800 are output | B |
A
B
With the wheels not contacting the ground, check the condition of the rear wheels when the electric parking brake is operating and not operating.
Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE ACTUATOR>ON-VEHICLE INSPECTION
| Proceed to |
|---|
| NEXT |
NEXT