84012 1.INSPECT INTEGRATION CONTROL AND PANEL SUB-ASSEMBLY (MULTI-TERRAIN SELECT SWITCH)
| *a | Component without harness connected (Integration Control and Panel Sub-assembly (Multi-Terrain Select Switch)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I88)Location & Routingewd_type=routing;type=c;code=I88 |
||
| I88-12 (PSW1) - I88-8 (E) | Multi-terrain select switch pushed and held | 138 Ω or less |
| I88-12 (PSW1) - I88-8 (E) | Multi-terrain select switch not pushed | 10 kΩ or higher |
If the result is not as specified, replace the integration control and panel sub-assembly (Multi-terrain select switch).
| *a | Component without harness connected (Integration Control and Panel Sub-assembly (Multi-Terrain Select Switch)) |
Apply battery voltage between the terminals of the integration control and panel sub-assembly (Multi-terrain select switch), and check the illumination condition of the integration control and panel sub-assembly (Multi-terrain select switch).
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → I88-7 (ILL+) Battery negative (-) → I88-1 (ILL-) |
Illuminates |
If the result is not as specified, replace the integration control and panel sub-assembly (Multi-terrain select switch).