Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM (w/ Variable Flow Control Solenoid Valve)
RM38G0E _55 Steering _100915 POWER ASSIST SYSTEMS _0469466 POWER STEERING SYSTEM(w/ Variable Flow Control Solenoid Valve) D

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM(w/ Variable Flow Control Solenoid Valve)  CALIBRATION  


STEERING ACTUATOR ECU INITIAL SETTING (ASSIST MAP WRITING) (USING GTS)


NOTICE:

If any of the following conditions are met, perform Steering Actuator ECU Initial Setting (assist map writing):

·

The power steering ECU with motor assembly has been replaced.

·

The electric power steering column sub-assembly has been replaced.

·

There is a difference in steering effort between turning left and right.



a.

Perform Steering Actuator ECU Initial Setting (assist map writing).

i.

Align the front wheels straight ahead and center the steering wheel.

Chassis > Steering Actuator > Utility
Tester Display
Steering Actuator ECU Initial Setting
50005 499 4783
NOTICE:
·

Do not turn the steering wheel sharply.

·

During the torque sensor zero point calibration the steering wheel will shudder. Do not touch the steering wheel until at least 3 seconds have elapsed after the shuddering has stopped.




ii.

Check for RoBs.

Chassis > Steering Actuator > Utility
Tester Display
Vehicle Control History (RoB)
50005 499 55
NOTICE:

When Steering Actuator ECU Initial Setting (assist map writing) are completed, make sure to check for vehicle control history (RoB).