Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM (w/ Variable Flow Control Solenoid Valve)
RM38G0E _55 Steering _100915 POWER ASSIST SYSTEMS _0469466 POWER STEERING SYSTEM(w/ Variable Flow Control Solenoid Valve) D

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM(w/ Variable Flow Control Solenoid Valve)  VEHICLE CONTROL HISTORY (RoB)  


DESCRIPTION


·

Vehicle Control History (RoB) is a function that captures and stores ECU data when triggered by specific vehicle behavior.

·

It may be possible to determine the cause of the malfunction by checking the vehicle history information and freeze frame data.

·

The number of possible stored Freeze Frame Data sets, whether multi Freeze Frame Data is available, the number of freeze frame points, Freeze Frame Data items, the ECU internal range, etc., is different depending on the stored group.

·

The stored data items for Vehicle Control History (RoB) Freeze Frame Data are different depending on the stored group. When the value of a data item does not change across all points, only the value of the detection point will be displayed. The content of the Freeze Frame Data is almost the same as that of the Data List.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM (w/ Variable Flow Control Solenoid Valve)>DATA LIST / ACTIVE TEST



PRECAUTIONS


·

As Vehicle Control History (RoB) may be overwritten whenever the trigger conditions are met, make sure to save Vehicle Control History (RoB) before performing any inspections.

·

As Vehicle Control History (RoB) may be stored when performing an Active Test, learning, etc., make sure to clear the Vehicle Control History (RoB) before returning the vehicle to the customer.



CHECK VEHICLE CONTROL HISTORY (RoB) (POWER STEERING SYSTEM)


a.

Using the GTS, check the Vehicle Control History (RoB).

Chassis > PPS > Utility
Tester Display
Vehicle Control History (RoB)
50005 405 55
Chassis > Steering Actuator > Utility
Tester Display
Vehicle Control History (RoB)
50005 499 55


Vehicle Control History (RoB) Item (Power Steering System)
FFD Group Code Tester Display Measurement Item Power Steering Warning Light Diagnostic Note
- X0455 Steering Angle Sensor Incorrect Installation History stored when a signal indicating incorrect assembly of the steering angle sensor is received Off Output ECU: Power steering ECU assembly
- X2001 Steering Angle Sensor Malfunction History stored when a steering angle malfunction signal or steering 0 point memory malfunction signal is received Off Output ECU: Power steering ECU assembly
- X200C Vehicle Speed Signal Invalidity
·

Latest vehicle speed signal invalid history

·

Latest vehicle speed signal fault control history (applicable only when CAN Vehicle Speed (SP1) is invalid)


Yellow Output ECU: Power steering ECU with motor assembly
Off Output ECU: Power steering ECU assembly
- X200D NE Signal Malfunction History stored when an engine speed malfunction signal is received Off Output ECU: Power steering ECU assembly
- X206D Power Source Stop Latest Engine Stall/READY OFF Control History Yellow Output ECU: Power steering ECU with motor assembly
- X21B4 High Load Continuation Latest High Load Continuous Control Number of Times Off Output ECU: Power steering ECU with motor assembly
- X21B5 Prevention of ECU/Motor Overheat Latest Overheat Prevention Control History Off Output ECU: Power steering ECU with motor assembly
- X21B6 Battery Voltage Drop
·

Latest Battery Voltage Drop History

·

Latest Power Supply Voltage Drop Control History

·

Latest Power Supply Voltage Drop Restraint Control History

·

Latest Chassis Power Supply Management EPS Control History

·

Latest Load Control History


Yellow or Off Output ECU: Power steering ECU with motor assembly
- X21B7 PPS Malfunction
·

History stored when power steering ECU failure information is abnormal

·

History stored when power steering ECU failure information is invalid


Yellow Output ECU: Power steering ECU with motor assembly
- X2600 Software Incompatibility with ENG/HV Control Module (Not Programmed) History stored when vehicle information (gasoline/HV) is not stored Red Output ECU: Power steering ECU with motor assembly
- X2601 Software Inconsistency with ENG/HV Control Module
·

History stored when Assist Map Writing has not been performed

·

History stored when assist map data does not match

·

History stored when vehicle information (gasoline/HV) does not match


Off Output ECU: Power steering ECU with motor assembly
- X2603 Software Inconsistency with Body Control Module
·

History stored when Assist Map Writing has not been performed

·

History stored when assist map data does not match


Off Output ECU: Power steering ECU with motor assembly
- X2605 Software Inconsistency with Brake Control Module
·

History stored when Assist Map Writing has not been performed

·

History stored when assist map data does not match


Off Output ECU: Power steering ECU with motor assembly
- X2606 Software Inconsistency with Suspension Control Module
·

History stored when Assist Map Writing has not been performed

·

History stored when assist map data does not match


Off Output ECU: Power steering ECU with motor assembly
- X2644 Torque Sensor Missing Calibration of Adjustment Value Non-Memory History stored when zero point calibration not performed Red Output ECU: Power steering ECU with motor assembly
- X2645 Torque Sensor Missing Calibration of Adjustment Incomplete History stored when zero point calibration failed Red Output ECU: Power steering ECU with motor assembly
- X2646 Assist Map Non-Memory History stored when Assist Map Writing has not been performed Red Output ECU: Power steering ECU with motor assembly
- XF01B ECU Security Key Not Registered ECU security key has not been updated Off Output ECU: Power steering ECU with motor assembly

CLEAR VEHICLE CONTROL HISTORY (RoB) (POWER STEERING SYSTEM)


a.

Using the GTS, check the Vehicle Control History (RoB).

Chassis > PPS > Utility
Tester Display
Vehicle Control History (RoB)
50005 405 55
Chassis > Steering Actuator > Utility
Tester Display
Vehicle Control History (RoB)
50005 499 55

b.

Press the DTC clear button.

NOTICE:

By performing this procedure, all stored Vehicle Control History (RoB) items will be cleared.