Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM (w/ Variable Flow Control Solenoid Valve) › 2021.04–2021.07
RM38G0E _55 Steering _100915 POWER ASSIST SYSTEMS _0469466 POWER STEERING SYSTEM(w/ Variable Flow Control Solenoid Valve) C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM(w/ Variable Flow Control Solenoid Valve)  C15F014  VFC Solenoid Circuit Circuit Short to Ground or Open  


DESCRIPTION

This circuit supplies electric power to the variable flow control solenoid valve (vane pump assembly).

The power steering ECU assembly controls the output current to the variable flow control solenoid valve (vane pump assembly) in accordance with the steering angle signal, steering zero point memory, vehicle speed signal and engine speed signal, adjusting the amount of power steering assist.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
C15F014 VFC Solenoid Circuit Circuit Short to Ground or Open A short or open in the solenoid valve circuit
·

Harness or connector

·

Vane pump assembly

·

Power steering ECU assembly


Output ECU: Power steering ECU assembly

DTC Detection Conditions: C15F014
Vehicle Condition
Pattern 1 Pattern 2
Diagnosis Condition - - -
Malfunction Status A short in the solenoid valve circuit ○ -
An open in the solenoid valve circuit - ○
Detection Time - -
Number of Trips 1 trip 1 trip

WIRING DIAGRAM

C411201E14
5.188,2.76 7.156,3.115 1.969,0.354 10 false Power Steering ECU Assembly 0.396,2.75 2.635,3.177 2.24,0.427 10 false Variable Flow Control Solenoid Valve (Vane Pump Assembly) 1.635,1.625 2.177,1.865 0.542,0.24 10 false SOF+ 5.333,1.531 5.875,1.771 0.542,0.24 10 false SOF+ 1.667,2 2.208,2.24 0.542,0.24 10 false SOF- 5.333,1.917 5.875,2.156 0.542,0.24 10 false SOF- 5.198,2.604 5.698,2.875 0.5,0.271 10 false I29 0.406,2.583 1,2.854 0.594,0.271 10 false C49 2.167,1.531 2.708,1.771 0.542,0.24 10 false 2 2.167,1.917 2.708,2.156 0.542,0.24 10 false 1 5.104,1.521 5.646,1.76 0.542,0.24 10 false 7 5.104,1.917 5.646,2.156 0.542,0.24 10 false 8

PROCEDURE

1.READ VALUE USING GTS (Solenoid Actual Current (PPS))
a.

Read the Data List according to the display on the GTS.

Chassis > PPS > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Solenoid Actual Current (PPS) Solenoid Current Min.: 0 mA
Max.: 1000 mA
200 to 950 mA: Engine running and steering wheel being turned -
Chassis > PPS > Data List
Tester Display
Solenoid Actual Current (PPS)
50003 405 803

OK:

The normal condition value is displayed on the GTS.


Result:
Proceed to
OK
NG



OK

REPLACE POWER STEERING ECU ASSEMBLY

NG

2.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU ASSEMBLY - VANE PUMP ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU ASSEMBLY - VANE PUMP ASSEMBLY)
a.

Disconnect the I29 power steering ECU assembly connector.


b.

Disconnect the C49 variable flow control solenoid valve (vane pump assembly) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(I29,C49)Location & Routing

Click Connector(I29)Instrument Panel>Instrument Panel Wire / Mobile Wireless Charger Cord / No. 1 Navigation Wire / No. 2 Instrument Panel Wire / No. 5 Instrument Panel Wire / Telephone Computer Wire>Power Steering ECU Assembly

Click Connector(C49)Engine Compartment>Connecting Wire / Cooling Fan Wire / Engine Wire / Fuel Pump Motor Wire / No. 1 Connecting Wire / No. 10 Engine Wire / No. 2 Connecting Wire / No. 3 Connecting Wire / No. 4 Connecting Wire / Sensor Wire / Turbocharger Wire>Vane Pump Assembly (Variable Flow Control Solenoid Valve)

I29-7 (SOF+) - C49-2 (SOF+) Always Below 1 Ω
I29-8 (SOF-) - C49-1 (SOF-) Always Below 1 Ω
I29-7 (SOF+) or C49-2 (SOF+) - Body ground Always 10 kΩ or higher
I29-8 (SOF-) or C49-1 (SOF-) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.INSPECT VANE PUMP ASSEMBLY

NG

REPAIR OR REPLACE HARNESS AND CONNECTOR

3.INSPECT VANE PUMP ASSEMBLY
a.

Disconnect the C49 variable flow control solenoid valve (vane pump assembly) connector.


b.

Measure the resistance according to the value(s) in the table below.

C308243C03
1.813,0.177 2.25,0.406 0.438,0.229 5.01,0.177 5.448,0.406 0.438,0.229 1.865,1.198 1.396,0.625 1.396,0.625 1.188,0.625 true 5.063,1.188 4.594,0.646 4.594,0.646 4.438,0.646 true 2.219,1.198 2.635,0.625 2.635,0.625 2.771,0.625 true 5.469,1.198 5.865,0.656 5.865,0.656 5.99,0.656 true 0.094,0.063 0.406,0.26 0.313,0.198 10 false *a 0.667,0.552 1.74,0.75 1.073,0.198 10 false 2(SOF+) 2.844,0.552 3.917,0.75 1.073,0.198 10 false 1(SOF-) 6.031,0.594 7.104,0.792 1.073,0.198 10 false 1(SOF-) 3.927,0.583 5,0.781 1.073,0.198 10 false 2(SOF+) 4.917,2.198 5.188,2.365 0.271,0.167 10 false (+) 5.5,2.198 6.573,2.396 1.073,0.198 10 false (-) 1.906,0.229 2.25,0.406 0.344,0.177 10 false C49 5.094,0.229 5.438,0.406 0.344,0.177 10 false C49
*a Component without harness connected
(Variable Flow Control Solenoid Valve (Vane Pump Assembly))
- -


Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(C49)Location & Routing

Click Connector(C49)Engine Compartment>Connecting Wire / Cooling Fan Wire / Engine Wire / Fuel Pump Motor Wire / No. 1 Connecting Wire / No. 10 Engine Wire / No. 2 Connecting Wire / No. 3 Connecting Wire / No. 4 Connecting Wire / Sensor Wire / Turbocharger Wire>Vane Pump Assembly (Variable Flow Control Solenoid Valve)

C49-1 (SOF-) - C49-2 (SOF+) 20°C (68°F) 6.7 to 7.3 Ω



c.

Connect the positive (+) lead of the battery with a 21 W bulb to terminal 2 (SOF+) and the negative (-) lead to terminal 1 (SOF-) of the solenoid valve connector. Then check that the valve moves and makes an operating noise.

OK:

Valve moves and makes an operating noise.



Result:
Proceed to
OK
NG



OK

REPLACE POWER STEERING ECU ASSEMBLY

NG