Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM
RM38G0E _56 Audio / Visual / Telematics _100728 PARK ASSIST / MONITORING _0469673 REAR VIEW MONITOR SYSTEM U

PARK ASSIST / MONITORING  REAR VIEW MONITOR SYSTEM  TERMINALS OF ECU  


CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY


E402719N01
1.427,1.865 1.802,2.167 0.375,0.302 3.396,1.854 3.771,2.156 0.375,0.302 1.51,1.927 1.969,2.125 0.458,0.198 10 false I11 3.49,1.917 3.948,2.115 0.458,0.198 10 false I13

a.

Disconnect the I11 and I13 radio and display receiver assembly connectors.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Terminal Description Condition Specified Condition
I11-1 (GND1) - Body ground Ground Always Below 1 Ω
I11-4 (+B1) - Body ground Battery Always 11 to 14 V
I11-15 (ACC1) - Body ground Power source of ACC Ignition switch off Below 1 V
Ignition switch ACC 11 to 14 V
I13-19 (IG) - Body ground Power source of IG Ignition switch off Below 1 V
Ignition switch ON 11 to 14 V


c.

Reconnect the I11 and I13 radio and display receiver assembly connectors.


d.

Measure the voltage and resistance and check for pulses according to the value(s) in the table below.

Terminal No. (Symbol) Terminal Description Condition Specified Condition
I11-28 (REV) - Body ground Reverse signal Ignition switch ON, shift position in R 11 to 14 V
Ignition switch ON, shift position not in R Below 1 V
I13-28 (V+) - I13-29 (V-) Display signal Ignition switch ON, shift position in R Pulse generation (See waveform 1)
Ignition switch ON, shift position in R, screen blacked out by covering camera lens Pulse generation (See waveform 2)
I13-30 (CA+) - I13-27 (CGND) Camera power source Ignition switch ACC 5.5 to 7.05 V
I13-27 (CGND) - Body ground Camera ground Always Below 1 Ω
I13-26 (CSLD) - Body ground Shield ground Always Below 1 Ω


e.
E159949N05
0.196,1.018 0.531,1.162 0.335,0.144 10 GND

Using an oscilloscope, check waveform 1.

Measurement Condition
Item Content
Terminal No. (Symbol) I13-28 (V+) - I13-29 (V-)
Tool Setting 200 mV/DIV., 50 μsec./DIV.
Condition Ignition switch ON, shift position in R, camera lens not covered, displaying an image


f.
E164781N04
0.275,1.002 0.612,1.146 0.337,0.145 10 GND

Using an oscilloscope, check waveform 2.

Measurement Condition
Item Content
Terminal No. (Symbol) I13-28 (V+) - I13-29 (V-)
Tool Setting 200 mV/DIV., 50 μsec./DIV.
Condition Ignition switch ON, shift position in R, camera lens covered, blacking out screen