Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM
RM38G0E _56 Audio / Visual / Telematics _100728 PARK ASSIST / MONITORING _0469672 PARKING ASSIST MONITOR SYSTEM C

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM  C1694  Steering Angle Initialization Incomplete  


DESCRIPTION

This DTC is stored when the rear television camera assembly judges that the maximum steering angle has not been memorized (steering angle setting is incomplete).

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
C1694 Steering Angle Initialization Incomplete Maximum steering angle has not been memorized (steering angle setting is incomplete)
·

Steering angle setting

·

Rear television camera assembly


Rear Camera A

CAUTION / NOTICE / HINT

NOTICE:
·

If the cable was disconnected from and reconnected to the negative (-) battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point".

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>INITIALIZATION

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION



PROCEDURE

1.PERFORM CALIBRATION
a.

Perform the following procedure depending on the memory conditions to register the vehicle information into the rear television camera assembly.



Result:
Proceed to
NEXT



NEXT

2.CHECK DTC OUTPUT
2.CHECK DTC OUTPUT
a.

Recheck for DTCs and check that no DTCs are output.

Chassis > Rear Camera > Trouble Codes
50001 85
HINT:
·

If DTC C1694 is output, perform the steering angle setting again.

·

If DTC C1694 is still output after performing the steering angle setting 3 times, replace the rear television camera assembly.




Result:
Result Proceed to
C1694 is not output A
C1694 is output B



A

END

B