Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR
RM38G0E _55 Steering _100925 STEERING GEAR / LINKAGE _0469952 STEERING GEAR G

STEERING GEAR / LINKAGE  STEERING GEAR  INSPECTION  


PROCEDURE

Hide 45047 1.INSPECT TIE ROD END SUB-ASSEMBLY LH

a.
C456135

Install the nut.


b.

Flip the ball joint stud back and forth 5 times as shown in the illustration.


c.

Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and check the torque reading on the 5th turn.

Torque:

0.98 to 3.92 N*m (10 to 39 kgf*cm, 9 to 34 in.*lbf)


HINT:

If the turning torque is not within the specified range, replace the tie rod end sub-assembly LH with a new one.



Hide 45046 2.INSPECT TIE ROD END SUB-ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.


Hide 3.INSPECT TOTAL PRELOAD

a.
C456136C01
2.146,0.75 2.479,0.75 true 1.781,1.24 1.333,0.917 1.333,0.917 1.083,0.917 true 2.531,0.667 2.802,0.885 0.271,0.219 10 false *1 0.885,0.823 1.198,1.073 0.313,0.25 10 false *a
*1 Dust Cover
*a Matchmark


Put matchmarks on the dust cover and steering link.


b.

Remove the dust cover.


c.

Temporarily install the 2 steering rack ends to the power steering rack.

NOTICE:

Do not fully turn the power steering rack without the steering rack ends as it may damage the oil seal in the rack housing.



d.
C457417N01
1.604,0.708 1.938,0.708 true 1.313,0.635 1.656,0.896 0.344,0.26 10 false SST

Using SST, fully turn the power steering rack right and left 10 times to settle it.

SST
09616-00011  


e.
C457418N01
2.063,0.625 2.396,0.625 true 2.469,0.531 2.958,0.771 0.49,0.24 10 false SST

Using SST, turn the control valve and measure the preload.

SST
09616-00011  

Standard preload (turning):
for Manual Tilt and Manual Telescopic Steering Column:

2.1 to 3.1 N*m (22 to 31 kgf*cm, 19 to 27 in.*lbf)

for Power Tilt and Power Telescopic Steering Column:

1.8 to 2.8 N*m (19 to 28 kgf*cm, 16 to 24 in.*lbf)


If the turning torque is not as specified, replace the power steering link.

NOTICE:

After setting the steering rack to the neutral point, align the dust cover rib with the power steering protrusion.


HINT:
·

Measure the standard preload at the steering rack neutral point.

·

The steering control valve is fully turned when turned 3.0 times. Half of the distance from the fully turned position is the neutral point.




f.

After inspecting the preload, align the matchmarks and install the dust cover.

HINT:

Perform the inspection with the steering link centered.