89458H 1.INSPECT NO. 2 FUEL PRESSURE SENSOR
Check the fuel pressure sensor output voltage.
| *a | Component without harness connected (No. 2 Fuel Pressure Sensor) |
| *b | Voltage Applied between Terminals |
Apply 5 V between terminals 1 (VC) and 3 (E2).
Be careful when connecting the leads, as the No. 2 fuel pressure sensor may be damaged if the leads are connected to the wrong terminals.
Do not apply more than 6 V to terminals 1 (VC) or 3 (E2).
If a stable power supply is not available, connect 4 nickel-metal hydride batteries (1.2 V each) or equivalent in series.
| *a | Component without harness connected (No. 2 Fuel Pressure Sensor) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(G4)Location & Routingewd_type=routing;type=c;code=G4 Click Connector(G4)Engine Compartment>No. 8 Engine Wire>Fuel Pressure Sensor (Low Pressure Side)ewd_type=component;type=c;code=G4;pinno=2,3 |
||
| G4-2(PFL) - G4-3(E2) | Pressure not applied to No. 2 fuel pressure sensor | Approximately 0.63 to 0.87 V* |
*: The output voltage changes depending on the voltage applied to the terminals.
If the result is not as specified, replace the No. 2 fuel pressure sensor.