89458 1.INSPECT FUEL PRESSURE SENSOR
Check the fuel pressure sensor output voltage.
| *a | Component without harness connected (Fuel Pressure Sensor) |
| *b | Voltage Applied between Terminals |
Apply 5 V between terminals 1 (VC) and 2 (E2).
Be careful when connecting the leads as the fuel pressure sensor may be damaged if the leads are connected to the wrong terminals.
Do not apply more than 6 V to terminals 1 (VC) or 2 (E2).
If a stable power supply is not available, connect 4 nickel-metal hydride batteries (1.2 V each) or equivalent in series.
| *a | Component without harness connected (Fuel Pressure Sensor) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(F4)Location & Routingewd_type=routing;type=c;code=F4 Click Connector(F4)Engine Compartment>No. 7 Engine Wire>Fuel Pressure Sensor (High Pressure Side)ewd_type=component;type=c;code=F4;pinno=3,2 |
||
| F4-3(PR) - F4-2(E2) | Pressure not applied to fuel pressure sensor | Approximately 0.4 to 0.6 V* |
*: The output voltage changes depending on the voltage applied to the terminals.
If the result is not as specified, replace the fuel pressure sensor.