Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › TURN ASSIST SWITCH
RM38G0E _54 Brake _100463 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0470299 TURN ASSIST SWITCH G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  TURN ASSIST SWITCH  INSPECTION  


PROCEDURE

Hide 84223A 1.INSPECT TRANSFER POSITION SWITCH (TURN ASSIST SWITCH)

a.
C453531C07
1.5,0.219 1.938,0.427 0.438,0.208 1.792,1.146 1.792,0.896 1.792,0.896 2.708,0.896 true 2,1.24 2.656,1.24 true 2.708,1.156 3.115,1.385 0.406,0.229 10 false GND2 2.771,0.823 3.125,1.021 0.354,0.198 10 false ECU 1.625,0.26 2.031,0.469 0.406,0.208 10 false I85 0.073,0.052 0.344,0.292 0.271,0.24 10 false *a
*a Component without harness connected
(Transfer Position Switch (Turn Assist Switch))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(I85)Location & Routing

Click Connector(I85)Instrument Panel>Instrument Panel Wire / Mobile Wireless Charger Cord / No. 1 Navigation Wire / No. 2 Instrument Panel Wire / No. 5 Instrument Panel Wire / Telephone Computer Wire>Transfer Position Switch

I85-2 (ECU) - I85-1 (GND2) Switch pushed Below 62.5 Ω
I85-2 (ECU) - I85-1 (GND2) Switch not pushed 10 kΩ or higher


HINT:

If the result is not as specified, replace the transfer position switch (turn assist switch).