84390B 1.INSPECT ELECTRIC PARKING BRAKE SWITCH ASSEMBLY (BRAKE HOLD SWITCH)
Check the resistance.
| *a | Component without harness connected (Electric Parking Brake Switch Assembly (Brake Hold Switch)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I89)Location & Routingewd_type=routing;type=c;code=I89 |
||
| I89-10 (SLT1) - I89-12 (E) | Switch pushed | Below 50 Ω |
| Switch not pushed | 10 kΩ or higher | |
If the result is not as specified, replace the electric parking brake switch assembly (brake hold switch).
Check the illumination.
| *a | Component without harness connected (Electric Parking Brake Switch Assembly (Brake Hold Switch)) |
Apply battery voltage to the electric parking brake switch assembly (brake hold switch).
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I89)Location & Routingewd_type=routing;type=c;code=I89 |
||
| I89-9 (ILL+) - I89-6 (ILL-) | I89-9 (ILL+) - Battery positive (+) I89-6 (ILL-) - Battery negative (-) |
Illuminates |
If the result is not as specified, replace the electric parking brake switch assembly (brake hold switch).