The cooler thermistor (duct sensor) (for LH Side) is installed in the rear quarter trim board to detect the rear room temperature, which is used to control the air conditioning system. The resistance of the cooler thermistor (duct sensor) (for LH Side) changes in accordance with the cabin temperature. As the temperature decreases, the resistance increases. As the temperature increases, the resistance decreases. The air conditioning amplifier assembly applies voltage (5 V) to the cooler thermistor (duct sensor) (for LH Side) and reads voltage changes due to changes in the resistance of the cooler thermistor (duct sensor) (for LH Side).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | DTC Output from | Priority |
|---|---|---|---|---|---|---|
| B147A11 | Rear Left Room Temperature Sensor Circuit Short to Ground | Diagnosis Condition: Ignition switch ON Malfunction Status: Short in rear room temperature sensor LH circuit Detection Time: Continuously for 4 seconds or more |
·
Cooler thermistor (duct sensor) (for LH Side)
·
Harness or connector
·
Air conditioning amplifier assembly |
Memorized | Air Conditioner | A |
Pre-procedure1
Disconnect the U1 cooler thermistor (duct sensor) (for LH Side) connector.
| *1 | Cooler Thermistor (Duct Sensor) (for LH Side) |
| *2 | Air Conditioning Amplifier Assembly |
Procedure1
According to the display on the GTS, read the Data List.
| Tester Display |
|---|
| Rear Left Room Temperature Sensor |
| GTS Display | Specified Condition |
|---|---|
| Rear Left Room Temperature Sensor | -327.68°C (-557.82°F) |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
Click hereVehicle Interior>HEATING / AIR CONDITIONING>ROOM TEMPERATURE SENSOR (for Rear Side)>REMOVAL
NG
Pre-procedure1
Disconnect the I30 air conditioning amplifier assembly connector.
Disconnect the U1 cooler thermistor (rear room temperature sensor LH) connector.
Procedure1
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I30,U1)Location & Routingewd_type=routing;type=c,c;code=I30,U1 Click Connector(U1)Body>No. 2 Room Wire>Cooler (Room Temperature Sensor) Thermistor Rear LHewd_type=component;type=c;code=U1;pinno=1,2 |
||
| I30-10 (RLTR) or U1-1 - Other terminals and body ground | Always | 10 kΩ or higher |
| I30-14 (SG-8) or U1-2 - Other terminals and body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG