Home › Engine / Hybrid System › V35A-FTS (INTAKE / EXHAUST) › INTAKE SYSTEM
RM38G0E _51 Engine / Hybrid System _101528 V35A-FTS INTAKE / EXHAUST _0470487 INTAKE SYSTEM G

V35A-FTS INTAKE / EXHAUST  INTAKE SYSTEM  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced when repairing air leaks in the intake system are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Air leaks from intake system is repaired Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION:
A345137

·

When working near the engine room while the engine has started or the power source mode is ignition switch ON, do not touch the fan and generator V belt or rotating components such as the fan, etc.

·

Touching the fan and generator V belt or rotating components such as the fan, etc. could result in your hand or clothing getting caught and pulled in.



PROCEDURE

Hide 1.INSPECT INTAKE SYSTEM

HINT:

Perform "Inspection After Repair" after repairing vacuum leaks in the intake system.

Click hereEngine / Hybrid System>V35A-FTS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.

Check that there are no vacuum leaks at the points shown in the illustration.

A486993


Hide 2.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after repairing vacuum leaks in the intake system.

Click hereEngine / Hybrid System>V35A-FTS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION