Home › Engine / Hybrid System › V35A-FTS (INTAKE / EXHAUST) › TURBOCHARGER
RM38G0E _51 Engine / Hybrid System _101528 V35A-FTS INTAKE / EXHAUST _0470492 TURBOCHARGER G

V35A-FTS INTAKE / EXHAUST  TURBOCHARGER  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS

a.

Check that there is no damage and cracks on the hoses and gaskets, and that there are no air or oil leaks from connections.

HINT:

Cracked hoses and gaskets or loose connections may cause the engine to run improperly or stall.



Hide 2.INSPECT TURBOCHARGER SUB-ASSEMBLY

NOTICE:

Perform this procedure in a safe location with another person.


a.

Start the engine and warm it up.


b.

Fully accelerate the vehicle with the shift lever in 3rd and measure the boost pressure when the engine speed is 3000 rpm (approximately 64 km/h (40 mph)).

Powertrain > Engine > Data List
Tester Display
Boost Pressure Sensor
50003 372 269
Standard Pressure:

90 kPa (0.9 kgf/cm2, 13 psi) or higher


If the result is not as specified, check the waste gate valve actuator with bracket assembly and turbocharger sub-assembly.