Home › Engine / Hybrid System › V35A-FTS (INTAKE / EXHAUST) › TURBOCHARGER
RM38G0E _51 Engine / Hybrid System _101528 V35A-FTS INTAKE / EXHAUST _0470492 TURBOCHARGER L

V35A-FTS INTAKE / EXHAUST  TURBOCHARGER  PRECAUTION  


MAINTENANCE PRECAUTION


a.

If the turbocharger sub-assembly is found to be defective, it must be replaced. Also, inspect the source of the trouble including the conditions under which the turbocharger sub-assembly was used. Repair or replace the following as necessary:

i.

Engine oil (level and quality)


ii.

Oil lines leading to the turbocharger sub-assembly



b.

Pay due attention when removing and reinstalling the turbocharger sub-assembly. Do not drop, strike, or grasp easily-deformed assembly parts.

NOTICE:
·
A487036

Do not hold the waste gate valve actuator rod.

·
A487037

When storing the turbocharger sub-assembly, do not store the assembly with the waste gate valve actuator facing down.

·

Make sure foreign matter does not enter the intake and exhaust ports and oil passage.




c.
A416772C03
0.323,1.552 0.542,1.552 0.542,1.552 1.031,1.302 true 1.302,0.656 1.656,0.313 1.656,0.313 1.875,0.313 false 1.927,0.198 2.24,0.354 0.313,0.156 10 false *1 0.146,1.458 0.458,1.615 0.313,0.156 10 false *a
*1 Turbo Oil Inlet Pipe Sub-assembly
*a Deposits


If replacing the turbocharger sub-assembly, check for deposits in the turbo oil inlet pipe sub-assembly. If necessary, replace the turbo oil inlet pipe sub-assembly.


d.
A487038C01
0.771,0.375 1.042,0.375 1.042,0.375 1.667,1.229 true 0.583,0.292 0.896,0.448 0.313,0.156 10 false *a
*a Oil Inlet Hole


If replacing the turbocharger sub-assembly, put 20 cc (1.2 cu. in.) of fresh engine oil into the turbocharger oil inlet hole and turn the turbine wheel by hand to spread oil over the bearing.