Home › Engine / Hybrid System › V35A-FTS (INTAKE / EXHAUST) › RADIATOR
RM38G0E _51 Engine / Hybrid System _101528 V35A-FTS INTAKE / EXHAUST _0470496 RADIATOR G

V35A-FTS INTAKE / EXHAUST  RADIATOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16475A 1.INSPECT RESERVE TANK CAP (for Intercooler)

a.

Measure the valve opening pressure.

i.
A487968C01
2.073,1.448 2.594,1.448 true 0.698,1.698 1.219,1.698 true 0.49,1.615 0.771,1.833 0.281,0.219 10 false *a 2.646,1.375 2.896,1.573 0.25,0.198 10 false *b
*a O-ring
*b Rubber Packing


If there are water stains or foreign matter on the O-ring, clean it with water and finger scouring.

NOTICE:

Always perform procedure by hand so as not to damage the O-ring.



ii.

Check that the O-ring is not deformed, cracked or swollen.


iii.

Apply engine coolant to the O-ring and rubber packing before using a radiator cap tester.


iv.
B008802C14
1.042,0.698 1.406,0.135 1.406,0.135 1.521,0.135 false 0.5,0.542 0.719,0.208 0.719,0.208 0.854,0.208 false 1.573,0.073 1.885,0.229 0.313,0.156 10 false *a 0.906,0.135 1.219,0.292 0.313,0.156 10 false *1 0.656,1.083 0.969,1.24 0.313,0.156 10 false *b
*1 Reserve Tank Cap (for Intercooler)
*a Radiator Cap Tester
*b 30° or more


When using the radiator cap tester, tilt it more than 30° degrees.


v.

Pump the radiator cap tester several times and check the maximum pressure*.

Pump speed:

1 pump per second


*: Even if the cap cannot maintain the maximum pressure, it is not a defect.

Standard Judgment Criterion:
Item Specified Condition
Standard value
(for brand-new cap)
93 to 123 kPa (1.0 to 1.3 kgf/cm2, 13.5 to 18 psi)
Minimum standard value
(for used cap)
79 kPa (0.8 kgf/cm2, 11.4 psi)


If the maximum pressure is less than the minimum standard value, replace the reserve tank cap (for Intercooler).