Home › Engine / Hybrid System › 1GR-FE (INTAKE / EXHAUST) › INTAKE SYSTEM
RM38G0E _51 Engine / Hybrid System _101533 1GR-FE INTAKE / EXHAUST _0470515 INTAKE SYSTEM G

1GR-FE INTAKE / EXHAUST  INTAKE SYSTEM  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the air leaks from intake system removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative when not Performed Link
Air leaks from intake system Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION:
A343690

To prevent injury due to contact with an operating fan and generator V-belt or cooling fan, keep your hand sand clothing away from the fan and generator V-belt and cooling fans when working in the engine compartment with the engine running.


PROCEDURE

Hide 1.INSPECT INTAKE SYSTEM

CAUTION:

To prevent injury due to contact with an operating fan and generator V-belt or cooling fan, keep your hand sand clothing away from the fan and generator V-belt and cooling fans when working in the engine compartment with the engine running.


HINT:

Perform "Inspection After Repair" after repairing air leaks in the intake system.

Click hereEngine / Hybrid System>1GR-FE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.

Check that there is no air suction at the pints shown in the illustration.

A486996