Home › Engine / Hybrid System › 1GR-FE (COOLING) › THERMOSTAT
RM38G0E _51 Engine / Hybrid System _101532 1GR-FE COOLING _0470523 THERMOSTAT G

1GR-FE COOLING  THERMOSTAT  INSPECTION  


PROCEDURE

Hide 16031 1.INSPECT WATER INLET SUB-ASSEMBLY WITH THERMOSTAT

A344506

HINT:

The valve opening temperature is inscribed on the thermostat.


a.

Immerse the thermostat in the water, then heat the water gradually.

CAUTION:
A342307

·

Do not your hands into the water that has been heated for the inspection.

·

Touching the heated water could result in burns.




b.

Check the valve opening temperature of the thermostat.

Standard valve opening temperature:

80 to 84°C (176 to 183°F)


If the valve opening temperature is not as specified, replace the water inlet sub-assembly with thermostat.


c.
A344507C01
2.51,1.698 2.823,1.854 0.313,0.156 10 false *a
*a Valve Lift


Check the valve lift.

Standard valve lift:

8.0 mm (0.315 in.) or more at 95°C (203°F)


If the valve lift is not as specified, replace the water inlet sub-assembly with thermostat.


d.

Check that the valve is fully closed when the thermostat is at low temperature (below 40°C (104°F)).

If not fully closed, replace the water inlet sub-assembly with thermostat.