81380D 1.INSPECT STEP LIGHT ASSEMBLY (for LH Side)
| *a | Component without harness connected (Step Light Assembly (for LH side)) |
Check the illumination.
Apply battery voltage to the step light assembly (for LH side) and check that the light illuminates.
| Tester Connection | Specified Condition |
|---|---|
Click Location & Routing(S17)Location & Routingewd_type=routing;type=c;code=S17 Click Connector(S17)Body>No. 2 Floor Wire / Step Rear Floor Wire LH>Step Light Assembly LHewd_type=component;type=c;code=S17;pinno=1,2 |
|
| Battery positive (+) - Terminal S17-1 | Step light assembly (for LH side) illuminates |
| Battery negative (-) - Terminal S17-2 | |
If the result is not as specified, replace the step light assembly (for LH side).
81380H 2.INSTALL STEP LIGHT ASSEMBLY (for RH Side)
| *a | Component without harness connected (Step Light Assembly (for RH side)) |
Check the illumination.
Apply battery voltage to the step light assembly (for RH side) and check that the light illuminates.
| Tester Connection | Specified Condition |
|---|---|
Click Location & Routing(Q25)Location & Routingewd_type=routing;type=c;code=Q25 |
|
| Battery positive (+) - Terminal Q25-1 | Step light assembly (for RH side) illuminates |
| Battery negative (-) - Terminal Q25-2 | |
If the result is not as specified, replace the step light assembly (for RH side).