Home › Suspension › SUSPENSION CONTROL › ELECTRONIC-KINETIC DYNAMIC SUSPENSION SYSTEM
RM38G0E _53 Suspension _100546 SUSPENSION CONTROL _0470891 ELECTRONIC-KINETIC DYNAMIC SUSPENSION SYSTEM D

SUSPENSION CONTROL  ELECTRONIC-KINETIC DYNAMIC SUSPENSION SYSTEM  VEHICLE CONTROL HISTORY (RoB)  


DESCRIPTION


·

Vehicle Control History is a function that captures and stores ECU data when triggered by specific vehicle behavior.

·

It may be possible to determine the cause of the malfunction by checking the vehicle history information and freeze frame data.

·

The number of possible stored Freeze Frame Data sets, whether multi Freeze Frame Data is available, the number of freeze frame points, Freeze Frame Data items, the ECU internal range, etc., is different depending on the stored group.

·

The stored data items for Vehicle Control History Freeze Frame Data are different depending on the stored group. When the value of a data item does not change across all points, only the value of the detection point will be displayed. The content of the Freeze Frame Data is almost the same as that of the Data List.

Click hereSuspension>SUSPENSION CONTROL>ELECTRONIC-KINETIC DYNAMIC SUSPENSION SYSTEM>DATA LIST / ACTIVE TEST



PRECAUTIONS


·

As Vehicle Control History may be overwritten whenever the trigger conditions are met, make sure to save Vehicle Control History before performing any inspections.

·

As Vehicle Control History may be stored when performing an Active Test, learning, etc., make sure to clear the Vehicle Control History before returning the vehicle to the customer.



CHECK VEHICLE CONTROL HISTORY


a.

Using the GTS, check the vehicle control history (RoB).

Chassis > Electronic-Kinetic Dynamic Suspension System (E-KDSS) > Utility
Tester Display
Vehicle Control History (RoB)
50005 5002 55
Code Tester Display Measurement Item Diagnostic Note
X0455 Steering Angle Sensor Wrong Installation Stores a history of receiving an incorrect steering sensor installation signal from the No. 2 skid control ECU (brake actuator assembly) via CAN communication -
X2001 Steering Angle Sensor Malfunction Stores a history of receiving a steering sensor steering angle value malfunction via CAN communication -
X2004 Speed Sensor Malfunction Stores a history of an invalid or abnormal speed sensor value received from the No. 2 skid control ECU (brake actuator assembly) via CAN communication -
X205C Supply Voltage Malfunction Stores a history that a power source voltage applied to the stabilizer control ECU is below 10.5 V or above 15.5 V -
X214B Lateral Acceleration Sensor Malfunction Stores a history of an invalid or abnormal lateral acceleration sensor value received via CAN communication from the No. 2 skid control ECU (brake actuator assembly) with a history of acceleration sensor malfunction -



CLEAR VEHICLE CONTROL HISTORY


a.

Using the GTS, display the vehicle control history (RoB).

Chassis > Electronic-Kinetic Dynamic Suspension System (E-KDSS) > Utility
Tester Display
Vehicle Control History (RoB)
50005 5002 55

b.

Select the clear button and follow the instructions on the screen to clear the vehicle control history.

NOTICE:

When the vehicle control history is cleared, all the stored history items are cleared.