1.INSPECT ABSORBER CONTROL ACTUATOR
| *A | for LH Side |
| *B | for RH Side |
| *a | Component without harness connected (Absorber Control Actuator) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(z11)Location & Routingewd_type=routing;type=c;code=z11 Click Connector(z11)Engine Compartment>other>Front Shock Absorber Assembly LH , Front Speed Sensor Wire LHewd_type=component;type=c;code=z11;pinno=1,5 |
||
| z11-1 (FAL+) - z11-5 (FAL-) | 15 to 25°C | 2.9 to 3.9 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(z12)Location & Routingewd_type=routing;type=c;code=z12 Click Connector(z12)Engine Compartment>other>Front Shock Absorber Assembly RH , Front Speed Sensor Wire RHewd_type=component;type=c;code=z12;pinno=1,5 |
||
| z12-1 (FAR+) - z12-5 (FAR-) | 15 to 25°C | 2.9 to 3.9 Ω |
If the result is not as specified, replace the front shock absorber assembly.