Home › Suspension › SUSPENSION CONTROL › ABSORBER CONTROL ACTUATOR (for Rear Side)
RM38G0E _53 Suspension _100546 SUSPENSION CONTROL _0472697 ABSORBER CONTROL ACTUATOR(for Rear Side) G

SUSPENSION CONTROL  ABSORBER CONTROL ACTUATOR(for Rear Side)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT ABSORBER CONTROL ACTUATOR

a.
A137227C22
1.583,0.365 1.917,0.531 0.333,0.167 1.583,0.083 1.917,0.25 0.333,0.167 0.75,0.969 1,0.969 1,0.969 1.417,1.302 true 2.677,0.969 2.427,0.969 2.427,0.969 2.01,1.302 true 0.104,0.083 0.417,0.281 0.313,0.198 10 false *a 0.615,0.896 0.865,1.146 0.25,0.25 10 false - 2.74,0.885 2.99,1.135 0.25,0.25 10 false + 1.688,0.094 2.021,0.344 0.333,0.25 10 false t3 1.677,0.375 2.01,0.625 0.333,0.25 10 false s3 2,0.094 2.333,0.344 0.333,0.25 10 false *A 2,0.375 2.333,0.625 0.333,0.25 10 false *B
*A for LH Side
*B for RH Side
*a Component without harness connected
(Absorber Control Actuator)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
for LH Side:
Tester Connection Condition Specified Condition

Click Location & Routing(t3)Location & Routing

Click Connector(t3)Body>No. 2 Parking Brake Wire Assembly>Rear Shock Absorber Assembly LH

t3-3 (+) - t3-1 (-) 15 to 25°C 2.8 to 4.4 Ω

for RH Side:
Tester Connection Condition Specified Condition

Click Location & Routing(s3)Location & Routing

Click Connector(s3)Body>No. 1 Parking Brake Wire Assembly>Rear Shock Absorber Assembly RH

s3-3 (+) - s3-1 (-) 15 to 25°C 2.8 to 4.4 Ω


If the result is not as specified, replace the rear shock absorber assembly.