Home › Drivetrain › AJA0F (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION SYSTEM (for V35A-FTS)
RM38G0E _52 Drivetrain _100435 AJA0F AUTOMATIC TRANSMISSION / TRANSAXLE _0472752 AUTOMATIC TRANSMISSION SYSTEM D

AJA0F AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM  CHECK MODE PROCEDURE  


DESCRIPTION


a.

Check mode has a higher sensitivity to malfunctions and can detect malfunctions that normal mode cannot detect. Check mode can also detect all of the malfunctions that normal mode can detect. In check mode, DTCs are detected with 1-trip detection logic.



CHECK MODE PROCEDURE


a.

Make sure that the following conditions are met:

i.

The battery voltage is 11 V or higher.


ii.

The throttle valve is fully closed.


iii.

The shift lever is in P or N.


iv.

The air conditioning is off.



b.

Turn the ignition switch off.


c.

Connect the GTS to the DLC3.


d.

Turn the ignition switch to ON.


e.

Turn the GTS on.


f.

Enter the following menus: Powertrain / Transmission / Utility / Check Mode.

Powertrain > Transmission > Utility
Tester Display
Check Mode
50005 373 1

g.
C140840E18
0.292,0.729 0.594,1.01 0.302,0.281 10 On 0.302,1.5 0.698,1.76 0.396,0.26 10 Off 2.021,0.448 3.083,0.688 1.063,0.24 10 0.13 seconds 1.906,1.771 2.938,2.01 1.031,0.24 10 0.13 seconds

Change the TCM to check mode. Make sure the MIL flashes as shown in the illustration.

NOTICE:

All DTCs and freeze frame data will be cleared if: 1) the GTS is used to change the TCM from normal mode to check mode or vice versa; or 2) during check mode, the ignition switch is turned from ON to ACC or off.

Before entering check mode, make a note of the DTCs and freeze frame data.



h.

Start the engine. The MIL should turn off after the engine starts.


i.

Perform Monitor Drive Pattern for the ECT.

Click hereDrivetrain>AJA0F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM (for V35A-FTS)>MONITOR DRIVE PATTERN

(Or, simulate the conditions of the malfunction described by the customer.)


j.

After simulating the malfunction conditions, use the GTS to check for DTCs and freeze frame data.