| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C183612 | Fr Stabilizer Solenoid B Control Circuit Circuit Short to Battery | Short circuit detected in solenoid valve |
·
Front stabilizer housing sub-assembly
·
Harness or connector
·
Stabilizer control ECU |
Electronic-Kinetic Dynamic Suspension System (E-KDSS) |
Disconnect the Q14 stabilizer control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(Q14)Location & Routingewd_type=routing;type=c;code=Q14 |
||
| Q14-5 (FNO+) - Body ground | Always | Below 1 V |
| Q14-6 (FNO-) - Body ground | Always | Below 1 V |
Connect the Q14 stabilizer control ECU connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the Q14 stabilizer control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(Q14)Location & Routingewd_type=routing;type=c;code=Q14 |
||
| Q14-5 (FNO+) - Body ground | Always | 10 kΩ or higher |
| Q14-6 (FNO-) - Body ground | Always | 10 kΩ or higher |
Connect the Q14 stabilizer control ECU connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected (Front Stabilizer Housing Sub-assembly) |
Disconnect the z13 front stabilizer housing sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 3 | 25°C (77°F) | 23.5 to 25.7 Ω |
Connect the z13 front stabilizer housing sub-assembly connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected (Front Speed Sensor RH) |
Disconnect the B13 front speed sensor RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (SBFU) - Body ground | Always | 10 kΩ or higher |
| 7 (CRFU) - Body ground | Always | 10 kΩ or higher |
Connect the B13 front speed sensor RH connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected (Front Stabilizer Housing Sub-assembly) |
Disconnect the z13 front stabilizer housing sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - Body ground | Always | 10 kΩ or higher |
| 3 - Body ground | Always | 10 kΩ or higher |
Connect the z13 front stabilizer housing sub-assembly connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG