Home › Suspension › SUSPENSION CONTROL › ELECTRONIC-KINETIC DYNAMIC SUSPENSION SYSTEM
RM38G0E _53 Suspension _100546 SUSPENSION CONTROL _0470891 ELECTRONIC-KINETIC DYNAMIC SUSPENSION SYSTEM C

SUSPENSION CONTROL  ELECTRONIC-KINETIC DYNAMIC SUSPENSION SYSTEM  C188104  ECU Malfunction System Internal Failure  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C188104 ECU Malfunction System Internal Failure Either condition is met:
·

A nonvolatile memory error occurs.

·

A malfunction occurs in the message register used for CAN communication.


Stabilizer control ECU Electronic-Kinetic Dynamic Suspension System (E-KDSS)

Vehicle Condition
Pattern 1 Pattern 2
Diagnosis Condition Ignition switch ON ○ ○
Malfunction Status A nonvolatile memory error occurs ○ -
A malfunction occurs in the message register used for CAN communication - ○
Detection Time - -
Number of Trips 1 trip 1 trip

HINT:

DTC will be output when conditions for either of the patterns in the table above are met.


PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Chassis > Electronic-Kinetic Dynamic Suspension System (E-KDSS) > Clear DTCs
50002 5002

b.

Turn the ignition switch off.


Result:
Proceed to
NEXT



NEXT

2.CHECK DTC
2.CHECK DTC
a.

Turn the ignition switch to ON.


b.

Check for DTCs.

Chassis > Electronic-Kinetic Dynamic Suspension System (E-KDSS) > Trouble Codes
50001 5002

c.

Turn the ignition switch off.


Result:
Result Proceed to
C188104 is output A
C188104 is not output B



A

B