| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| U010087 | Lost Communication With ECM/PCM "A" Missing Message | Stabilizer control ECU loses CAN communication with ECM | CAN communication system | Electronic-Kinetic Dynamic Suspension System (E-KDSS) |
| U010187 | Lost Communication with TCM Missing Message | Stabilizer control ECU loses CAN communication with transmission control ECU assembly | CAN communication system | Electronic-Kinetic Dynamic Suspension System (E-KDSS) |
| U011487 | Lost Communication with Four-Wheel Drive Clutch Control Module Missing Message | Stabilizer control ECU loses CAN communication with 4 wheel drive control ECU | CAN communication system | Electronic-Kinetic Dynamic Suspension System (E-KDSS) |
| U012687 | Lost Communication with Steering Angle Sensor Module Missing Message | Stabilizer control ECU loses CAN communication with steering sensor | CAN communication system | Electronic-Kinetic Dynamic Suspension System (E-KDSS) |
| U012987 | Lost Communication with Brake System Control Module "A" Missing Message | Stabilizer control ECU loses CAN communication with No. 2 skid control ECU (brake actuator assembly) | CAN communication system | Electronic-Kinetic Dynamic Suspension System (E-KDSS) |
Clear the DTCs.
Turn the ignition switch off.
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch to ON.
Check for DTCs.
Turn the ignition switch off.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING