84724C 1.INSPECT REAR DIFFERENTIAL LOCK SWITCH
| *a | Component without harness connected (Rear Differential Lock Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I91)Location & Routingewd_type=routing;type=c;code=I91 |
||
| I91-5 (RRB) - I91-2 (RRE) | Pressed | Below 25 Ω |
| Not pressed | 1 MΩ or higher | |
If the result is not as specified, replace the rear differential lock switch.
| *a | Component without harness connected (Rear Differential Lock Switch) |
| *b | Indicator |
Check that the LED illuminates.
Apply battery voltage between the terminals of the rear differential lock switch, and check the illumination condition.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I91)Location & Routingewd_type=routing;type=c;code=I91 |
||
| I91-6(ILL+) - I91-1(ILL-) | I91-6(ILL+) - Auxiliary battery positive (+) I91-1(ILL-) - Auxiliary battery negative (-) |
Illuminates |
If the result is not as specified, replace the rear differential lock switch.