84222Q 1.INSPECT DIFFERENTIAL LOCK INDICATOR SWITCH
| *a | Component without harness connected (Differential Lock Indicator Switch (Rear Differential Lock Position Switch)) |
|
ON |
|
OFF |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
Click Location & Routing(V12)Location & Routingewd_type=routing;type=c;code=V12 Click Connector(V12)Body>Differential Wire / Frame Wire>Differential Position Switch (Rear Differential Assembly)ewd_type=component;type=c;code=V12;pinno=1,2 |
||
| V12-1(GND) - V12-2 (RLY2) | ON | Below 1 Ω |
| OFF | 10 kΩ or higher | |
If the result is not as specified, replace the differential lock indicator switch.