Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR (w/ Electronic-Kinetic Dynamic Suspension System)
RM38G0E _53 Suspension _102028 FRONT SUSPENSION _0473052 FRONT STABILIZER BAR(w/ Electronic-Kinetic Dynamic Suspension System) G

FRONT SUSPENSION  FRONT STABILIZER BAR(w/ Electronic-Kinetic Dynamic Suspension System)  INSPECTION  


PROCEDURE

Hide 48810 1.INSPECT FRONT STABILIZER LINK ASSEMBLY

F049932

a.

As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut.


b.

Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the fifth turn.

Turning torque:

1.0 to 5.0N*m (10.2 to 50.0 kgf*cm, 8.9 to 44.2 in.*lbf)



c.

Check for any cracks and grease leaks on the ball joint dust cover.