Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR (w/o Electronic-Kinetic Dynamic Suspension System)
RM38G0E _53 Suspension _102028 FRONT SUSPENSION _0473053 FRONT STABILIZER BAR(w/o Electronic-Kinetic Dynamic Suspension System) G

FRONT SUSPENSION  FRONT STABILIZER BAR(w/o Electronic-Kinetic Dynamic Suspension System)  INSPECTION  


PROCEDURE

Hide 48810 1.INSPECT FRONT STABILIZER LINK ASSEMBLY LH

C328536

a.

As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut.


b.

Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn.

Turning torque:

0.5 to 3.4 N*m (5.0 to 34.6 kgf*cm, 4.43 to 30.0 in.*lbf)



c.

Check for any cracks and grease leaks on the ball joint dust cover.