Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for V35A-FTS)
RM38G0E _55 Steering _100915 POWER ASSIST SYSTEMS _0468432 VANE PUMP(for V35A-FTS) G

POWER ASSIST SYSTEMS  VANE PUMP(for V35A-FTS)  INSPECTION  


PROCEDURE

Hide 1.INSPECT CLEARANCE BETWEEN VANE PUMP SHAFT AND BUSHING IN FRONT HOUSING

a.
C202404N01
2.531,1.021 2.74,0.521 2.74,0.521 2.906,0.521 true 0.396,1.052 0.688,1.25 0.292,0.198 10 false (a) 2.958,0.427 3.229,0.635 0.271,0.208 10 false (b)

Using a micrometer, measure the diameter (a) of the shaft with pulley.


b.

Using a caliper gauge, measure the inside diameter (b) of the front housing.

NOTICE:

Do not damage the bushing in the front housing.



c.

Subtract (a) from (b) to calculate the oil clearance.

Maximum clearance:

0.07 mm (0.00276 in.)


If the clearance is more it is more than the maximum, replace the shaft with pulley.


Hide 2.INSPECT VANE PUMP ROTOR AND VANE PUMP PLATES CLEARANCE

a.
C101978

Using a feeler gauge, measure the clearance between the side face of the vane pump rotor groove and the vane pump plates.

Maximum clearance:

0.03 mm (0.00118 in.)


If the clearance is more than the maximum, replace the vane pump plates, vane pump rotor and vane pump cam ring.

HINT:

Refer to the following table to select an appropriate combination of vane pump rotor, vane pump cam ring and vane pump plates.


Combination of Vane Pump Rotor, Vane Pump Cam Ring and Vane Pump Plates:
Vane Pump Cam Ring Part No. Vane Pump Rotor Part No. Vane Plate Part No.
44325-60120 44313-60020 44345-60070
44325-60130 44313-60030 44345-60080
44325-60140 44313-60040 44345-60090
44325-60150 44313-60050 44345-60100



Hide 3.INSPECT PRESSURE PORT UNION

a.

If the union seat in the pressure port union sub-assembly is severely damaged, replace the pressure port union sub-assembly.