| Fuel pressure | Standard fuel pressure | 321 to 327 kPa (3.3 to 3.3 kgf/cm2, 46.5 to 47.4 psi) |
| Remains for 5 minutes after engine has stopped | 147 kPa (1.5 kgf/cm2, 21 psi) or higher |
| Fuel injector assembly | Standard resistance | 11.6 to 12.4 Ω at 20°C (68°F) |
| Standard injection volume | 71 to 85 cc (4.3 to 5.2 cu.in.) per 15 seconds | |
| Difference between each fuel injector | 14 cc (0.9 cu. in.) or less | |
| Standard fuel drop | 1 drop or less per 17 minutes |
| Fuel pump | Tester Connection | Specified Condition |
| U - V | 0.05 to 3.0 Ω | |
| V - W | 0.05 to 3.0 Ω | |
| U - W | 0.05 to 3.0 Ω |
|
*: The output voltage changes depending on the voltage applied to the terminals. |
|||
| Fuel sender gauge assembly | Tester Connection | Condition | Specified Condition |
| V8-2(FE) - V8-3(FR) | Float position is F (upper) |
Approximately 4.255 to 4.605 V* | |
| Float position is E (lower) |
Approximately 0.345 to 0.695V* | ||
| No. 2 fuel sender gauge assembly | Tester Connection | Condition | Specified Condition |
| V10-2(FE2) - V10-3(FR2) | Float position is F (upper) |
Approximately 4.255 to 4.605 V* | |
| Float position is E (lower) |
Approximately 0.345 to 0.695V* | ||