Home › General › MAINTENANCE › DIFFERENTIAL OIL
RM38G0E _V1 General _100461 MAINTENANCE _0473791 DIFFERENTIAL OIL A

MAINTENANCE  DIFFERENTIAL OIL  REPLACEMENT  


PROCEDURE

Hide 1.DRAIN DIFFERENTIAL OIL

a.

Stop the vehicle on a level place.


b.

for Front Differential:

i.

Remove the No. 1 engine under cover assembly.


ii.

Remove the No. 2 engine under cover assembly.


iii.
C457997

Using a 10 mm hexagon wrench, remove the filler plug and gasket.


iv.
C457995

Using a 10 mm hexagon wrench, remove the drain plug and gasket, and drain the oil.


v.

Using a 10 mm hexagon wrench, install a new gasket and the drain plug.

Torque:
39.2 N*m (400 kgf*cm, 29 ft.*lbf)



c.

for Rear Differential:

i.
C457998

Remove the filler plug and gasket.


ii.
C457996

Remove the drain plug and gasket, and drain the oil.


iii.

Install a new gasket and the drain plug.

Torque:
49 N*m (500 kgf*cm, 36 ft.*lbf)



Hide 2.ADD DIFFERENTIAL OIL

a.
D025304E76
0.146,1.188 0.854,1.354 0.708,0.167 10 false 0 to 5 mm

Add differential oil so that the oil level is between 0 to 5 mm (0 to 0.197 in.) from the bottom lip of the differential filler plug hole.

NOTICE:
·

Too much or too little oil will lead to differential problems.

·

After changing the oil, drive the vehicle and then check the oil level again.



Front differential oil type and viscosity:

Toyota Genuine Differential gear oil LT 75W-85 GL-5 or equivalent


Rear Differential Oil Type and Viscosity:
Item Oil Type and Viscosity
except LSD Toyota Genuine Differential gear oil LT 75W-85 GL-5 or equivalent
for LSD Toyota Genuine Differential gear oil LX 75W-85 GL-5 or equivalent


Front differential capacity:
Item Standard Differential Oil Capacity
w/ Differential Lock 1.27 to 1.37 liters (1.34 to 1.45 US qts, 1.12 to 1.21 Imp. qts)
w/o Differential Lock 1.11 to 1.21 liters (1.17 to 1.28 US qts, 0.98 to 1.06 Imp. qts)


Rear Differential Capacity:
Engine Item Standard Differential Oil Capacity
except 1GR-FE w/ Differential Lock 5.13 to 5.23 liters (5.42 to 5.53 US qts, 4.51 to 4.60 Imp. qts)
w/o Differential Lock 5.40 to 5.50 liters (5.71 to 5.81 US qts, 4.75 to 4.84 Imp. qts)
for LSD 5.20 to 5.30 liters (5.50 to 5.60 US qts, 4.58 to 4.66 Imp. qts)
for 1GR-FE w/ Differential Lock 4.86 to 4.96 liters (5.14 to 5.24 US qts, 4.28 to 4.36 Imp. qts)
w/o Differential Lock 5.42 to 5.52 liters (5.73 to 5.83 US qts, 4.77 to 4.86 Imp. qts)



b.

for Front Differential:

i.

Using a 10 mm hexagon wrench, install a new gasket and the filler plug.

Torque:
39.2 N*m (400 kgf*cm, 29 ft.*lbf)


ii.

Install the No. 2 engine under cover assembly.


iii.

Install the No. 1 engine under cover assembly.



c.

for Rear Differential:

i.

Install a new gasket and the filler plug.

Torque:
49 N*m (500 kgf*cm, 36 ft.*lbf)