84724A 1.INSPECT FRONT DIFFERENTIAL LOCK SWITCH
| *a | Component without harness connected (Front Differential Lock Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I90)Location & Routingewd_type=routing;type=c;code=I90 |
||
| I90-5 (FRB) - I90-2 (FRE) | Pressed | Below 25 Ω |
| Not pressed | 1 MΩ or higher | |
If the result is not as specified, replace the front differential lock switch.
| *a | Component without harness connected (Front Differential Lock Switch) |
| *b | Indicator |
Check that the LED illuminates.
Apply battery voltage between the terminals of the front differential lock switch, and check the illumination condition.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I90)Location & Routingewd_type=routing;type=c;code=I90 |
||
| I90-6(ILL+) - I90-1(ILL-) | I90-6(ILL+) - Auxiliary battery positive (+) I90-1(ILL-) - Auxiliary battery negative (-) |
Illuminates |
If the result is not as specified, replace the front differential lock switch.