Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type, for 12.3 Inch Display)
RM38G0E _56 Audio / Visual / Telematics _100606 AUDIO / VIDEO _0467496 AUDIO AND VISUAL SYSTEM(for Radio and Display Type, for 12.3 Inch Display) L

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type, for 12.3 Inch Display)  PRECAUTION  


PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL


NOTICE:

After the ignition switch is turned off, the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) battery terminal.



PRECAUTION FOR AUDIO AND VISUAL SYSTEM


NOTICE:
·

After performing any of the following procedures, the audio and visual system may restart after the ignition switch to ACC for first time (due to radio receiver assembly and navigation ECU assembly certification).

-

Disconnecting and reconnecting the cable to the negative (-) terminal of the battery, replacing the battery, or recharging the battery after being discharged.

-

Removing and installing or replacing the radio receiver assembly or navigation ECU assembly.


·

When replacing the telephone transceiver assembly, make sure to replace it with a new one. (w/ Telematics Transceiver)

·

After replacing the radio receiver assembly, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display assembly, update the software of the navigation ECU assembly.

·

After replacing the navigation ECU assembly, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display assembly, update the software of the radio receiver assembly.

·

When replacing the integration control sub-assembly, always replace it with a new one. If an integration control sub-assembly which was installed to another vehicle is used, the following may occur:

-

A communication malfunction DTC may be stored.

-

The integration control sub-assembly may not operate normally.




a.

If any of the following parts are replaced, refer to Work Procedure of When Replacing or Removing/Installing Parts.

Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>WORK PROCEDURE

·

Telephone transceiver assembly*


*: w/ Telematics Transceiver