The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio receiver assembly via this circuit.
| *a | Front view of wire harness connector (to Radio Receiver Assembly) |
| *b | Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly) |
Disconnect the I161 radio receiver assembly connector.
Disconnect the I162 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I161,I162)Location & Routingewd_type=routing;type=c,c;code=I161,I162 |
||
| I161-2 (US1-) - I162-9 (UDO-) | Always | Below 1 Ω |
| I161-3 (US1+) - I162-10 (UDO+) | Always | Below 1 Ω |
| I161-5 (USG1) - I162-[12] (UJSS) | Always | Below 1 Ω |
| I161-2 (US1-) or I162-9 (UDO-) - Body ground | Always | 10 kΩ or higher |
| I161-3 (US1+) or I162-10 (UDO+) - Body ground | Always | 10 kΩ or higher |
| I161-5 (USG1) or I162-[12] (UJSS) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG