25702B 1.INSPECT NO. 2 EMISSION CONTROL VALVE SET
| *a | Component without harness connected (No. 2 Emission Control Valve Set) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(C95)Location & Routingewd_type=routing;type=c;code=C95 |
||
| C95-1(GNDL) - C95-5(+BL) | 20°C (68°F) | 4.5 to 5.5 Ω |
| C95-1(GNDL) - Body ground | Always | 1 MΩ or higher |
| C95-5(+BL) - Body ground | ||
When measuring the resistance, do not touch terminals 2, 3 or 4.
When measuring the resistance make sure that the surface temperature of the No. 2 emission control valve set is 20°C.
If the result is not as specified, replace the No. 2 emission control valve set.
| *a | Air |
| *b | Port A |
| *c | Port B |
Check the operation of the No. 2 emission control valve set.
Check that air does not flow from port A to port B.
Make sure the applied pressure is 30 kPa (0.3 kgf/cm2, 4.4 psi) or less.
If the result is not as specified, replace the No. 2 emission control valve set.
| *a | Air |
| *b | Port A |
| *c | Port B |
Apply battery voltage across terminals 1 and 5.
When applying voltage, do not touch terminals 2, 3 or 4.
Check that air flows from port A to port B.
If the result is not as specified, replace the No. 2 emission control valve set.