RM38G0E _V1 General _100727 SPECIFICATIONS _0478866 1GR-FE STARTING F
SPECIFICATIONS 1GR-FE STARTING SERVICE DATA
STARTER
| Starter assembly |
No-load characteristics current |
Standard current |
90 A or less at 11.5 V |
| Magnet starter switch assembly |
Terminal 50 - Terminal C |
Standard Resistance |
Below 1 Ω |
| Terminal 50 - Switch Body |
Standard Resistance |
Below 2 Ω |
| Starter brush holder assembly |
Spring load |
Standard |
18 to 24 N (1.8 to 2.4 kgf, 4.0 to 5.4 lbf) |
| Minimum |
12 N (1 kgf, 2.7 lbf) |
| Positive (+) Brush Holder - Negative (-) Brush Holder |
Standard Resistance |
10 kΩ or higher |
| Brush length |
Standard |
15.5 mm (0.610 in.) |
| Minimum |
8.5 mm (0.335 in.) |
| Starter yoke assembly |
Lead Wire - Brush |
Standard Resistance |
Below 1 Ω |
| Starter Yoke Body - Brush |
Standard Resistance |
10 kΩ or higher |
| Brush length |
Standard |
15.5 mm (0.610 in.) |
| Minimum |
8.5 mm (0.335 in.) |
| Starter armature assembly |
Segment - Segment |
Standard Resistance |
Below 1 Ω |
| Segment - Coil Core |
Standard Resistance |
10 kΩ or higher |
| Circle runout |
Maximum |
0.05 mm (0.00197 in.) |
| Commutator diameter |
Standard |
30.0 mm (1.18 in.) |
| Minimum |
29.0 mm (1.14 in.) |
| Undercut depth |
Standard |
0.6 mm (0.0236 in.) |
| Minimum |
0.2 mm (0.00787 in.) |
ENGINE SWITCH
| Engine switch |
12 (SS1) -3 (GND) 6 (SS2) -3 (GND) 11 (SS3) -3 (GND) |
Not pushed |
10 kΩ or higher |
| Pushed |
Below 1 Ω |
RELAY
| STARTER RELAY (ST NO. 1) |
3 - 5 |
Battery voltage not applied to terminals 1 and 2 |
10 kΩ or higher |
| Battery voltage applied to terminals 1 and 2 |
Below 1 Ω |