RM38G0E _V1 General _100727 SPECIFICATIONS _0480011 SUSPENSION CONTROL F
SPECIFICATIONS SUSPENSION CONTROL SERVICE DATA
Front Acceleration Sensor
| Tester Connection |
Condition |
Specified Condition |
| for LHD |
1 (SGFL) - 2 (SGG) |
Sensor stationary |
Approx. 2.0 to 2.5 V |
| Sensor vibrating vertically |
Changes between approx. 0.9 and 3.6 V |
| 1 (SGFR) - 2 (SGG) |
Sensor stationary |
Approx. 2.0 to 2.5 V |
| Sensor vibrating vertically |
Changes between approx. 0.9 and 3.6 V |
| for RHD |
1 (SGFR) - 2 (SGG) |
Sensor stationary |
Approx. 2.0 to 2.5 V |
| Sensor vibrating vertically |
Changes between approx. 0.9 and 3.6 V |
| 1 (SGFL) - 2 (SGG) |
Sensor stationary |
Approx. 2.0 to 2.5 V |
| Sensor vibrating vertically |
Changes between approx. 0.9 and 3.6 V |
Absorber Control Actuator (for Front Side)
| Tester Connection |
Condition |
Specified Condition |
| for LH Side |
1 (FAL+) - 5 (FAL-) |
15 to 25°C |
2.9 to 3.9 Ω |
| for RH side |
1 (FAR+) - 5 (FAR-) |
15 to 25°C |
2.9 to 3.9 Ω |
Absorber Control Actuator (for Rear Side)
| Tester Connection |
Condition |
Specified Condition |
| for LH Side |
3 (+) - 1 (-) |
15 to 25°C |
2.8 to 4.4 Ω |
| for RH side |
3 (+) - 1 (-) |
15 to 25°C |
2.8 to 4.4 Ω |
Combination Switch
| Tester Connection |
Switch Condition |
Specified Condition |
| 5 (PSW2) - 8 (E) |
Drive mode switch being pushed and held |
138 Ω or less |
| Drive mode switch not pushed |
10 kΩ or higher |
Combination Switch (Integration Control and Panel Sub-assembly (Transfer Position Switch)
| Tester Connection |
Switch Condition |
Specified Condition |
| 8 (2WD) - 1 (GND2) |
Transfer position switch L4 |
66 Ω or less |
| Transfer position switch H4 |
10 kΩ or higher |