Home › Engine / Hybrid System › F33A-FTV (COOLING) › RADIATOR › from 2021.07
RM38G0E _51 Engine / Hybrid System _106334 F33A-FTV COOLING _0484473 RADIATOR G

F33A-FTV COOLING  RADIATOR  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

CAUTION:
A487150

Do not remove the reserve tank cap or drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


PROCEDURE

Hide 16475A 1.CHECK RESERVE TANK CAP

CAUTION:

Do not remove the reserve tank cap or drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


a.

Visually check the reserve tank cap.

i.
A287226C11
0.677,1.948 0.844,1.948 0.844,1.948 1.229,1.708 false 2.844,1.802 2.656,1.802 2.656,1.802 2.052,1.458 true 0.427,1.854 0.667,2.021 0.24,0.167 10 false *a 2.906,1.729 3.135,1.906 0.229,0.177 10 false *b
*a Packing
*b Gasket


If there are water stains or foreign matter on the packing, clean it with water and finger scouring.


ii.

Check that the packing is not deformed, cracked or swollen.



b.

Measure the valve opening pressure.

i.

Apply engine coolant to the packing and gasket before using a radiator cap tester.


ii.
B008802C17
0.479,0.563 0.667,0.198 0.667,0.198 0.833,0.198 false 1.021,0.708 1.365,0.198 1.365,0.198 1.531,0.198 false 0.885,0.083 1.198,0.24 0.313,0.156 10 false *1 1.594,0.083 1.906,0.24 0.313,0.156 10 false *a 0.531,1.052 0.844,1.208 0.313,0.156 10 false *b
*1 Reserve Tank Cap
*a Radiator Cap Tester
*b 30° or more


When using the radiator cap tester, tilt it upward 30° or more.


iii.

Pump the radiator cap tester several times, and check the maximum pressure.

Pumping Speed:

1 pump per second


Result:
Item Specified Condition
Standard pressure
(for brand-new reserve tank cap)
94 to 122 kPa (1.0 to 1.2 kgf/cm2, 13.6 to 17 psi)
Minimum pressure
(for used reserve tank cap)
79 kPa (0.8 kgf/cm2, 11.5 psi)


HINT:

Even if the reserve tank cap cannot maintain the maximum pressure, it is not a defect.


If the maximum pressure is less than the minimum pressure, replace the reserve tank cap.