79245A 1.INSPECT NO. 2 SEAT CUSHION PAD LH (OCCUPANT DETECTION SENSOR)
| *a | Component without harness connected (No. 2 Seat Cushion Pad LH (Occupant Detection Sensor)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(n4)Location & Routingewd_type=routing;type=c;code=n4 Click Connector(n4)Body>No. 2 Rear Seat Wire LH>Belt Warning Occupant Detection Sensor (No. 2 Seat Cushion Pad LH)ewd_type=component;type=c;code=n4;pinno=1,2 |
||
| n4-1 - n4-2 | Occupied | Below 100 Ω |
| Not occupied | 1 MΩ or higher | |
If the result is not as specified, replace the No. 2 seat cushion pad LH (occupant detection sensor).
79235F 2.INSPECT NO. 2 SEAT CUSHION PAD RH (OCCUPANT DETECTION SENSOR)
| *a | Component without harness connected (No. 2 Seat Cushion Pad RH (Occupant Detection Sensor)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(m4)Location & Routingewd_type=routing;type=c;code=m4 Click Connector(m4)Body>No. 2 Rear Seat Wire RH>Belt Warning Occupant Detection Sensor (No. 2 Seat Cushion Pad RH)ewd_type=component;type=c;code=m4;pinno=1,2 |
||
| m4-1 - m4-2 | Occupied | Below 100 Ω |
| Not occupied | 1 MΩ or higher | |
If the result is not as specified, replace the No. 2 seat cushion pad RH (occupant detection sensor).