1. A/T CODE REGISTRATION
When the TCM is replaced, perform "A/T Code Registration".
Perform A/T Code Registration (Read Compensation Code) and A/T Code Registration (Set Compensation Code)
When the TCM (when the transmission compensation code can be read) is replaced, perform A/T Code Registration (Read Compensation Code) before replacement.
After the TCM is replaced, perform A/T Code Registration (Set Compensation Code) and perform drive learning.
Make sure the shift lever is in P or N.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Do not start the engine
Turn the GTS on.
Enter the following menus: Powertrain / Transmission / Utility / A/T Code Registration.
| Tester Display |
|---|
| A/T Code Registration |
Select "Read Compensation Code".
Perform A/T Code Registration (Read Compensation Code) according to the screen display.
If the compensation code cannot be read, perform drive learning after A/T Code Registration (Fixed Code).
Turn the ignition switch off.
Replace the TCM.
Turn the ignition switch to ON.
Do not start the engine.
Turn the GTS on.
Enter the following menus: Powertrain / Transmission / Utility / A/T Code Registration.
| Tester Display |
|---|
| A/T Code Registration |
Select "Set Compensation Code".
Perform A/T Code Registration (Set Compensation Code) according to the screen display.
2. A/T CODE REGISTRATION (FIXED CODE)
When the TCM is replaced, perform "A/T Code Registration".
Perform A/T Code Registration (Fixed Code)
When the TCM (when the transmission compensation code cannot be read) is replaced, perform A/T Code Registration (Fixed Code) after replacement, and then perform drive learning.
Make sure the shift lever is in P or N.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Do not start the engine
Turn the GTS on.
Enter the following menus: Powertrain / Transmission / Utility / A/T Code Registration (Fixed Code).
| Tester Display |
|---|
| A/T Code Registration (Fixed Code) |
Perform A/T Code Registration (Fixed Code) according to the screen display.