CHECK COMBINATION METER ASSEMBLY
Check speedometer operation
The combination meter assembly receives the vehicle speed signal from the brake actuator assembly (No. 2 skid control ECU) via CAN communication. Therefore, perform the following inspection referring to values on the Data List of the brake actuator assembly (No. 2 skid control ECU) because it is the source of the vehicle speed signal.
Data List values of the brake actuator assembly (No. 2 skid control ECU) are used for this inspection. Therefore, make sure to perform this inspection after confirming that DTCs are not output.
Warm up the engine.
Put the engine in inspection mode (maintenance mode).
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE
Enter the following menus: Chassis / Brake/EPB / Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Vehicle Speed | Vehicle speed (Vehicle speed signal output to combination meter assembly) |
Min.: 0.0 km/h (0 mph) Max.: 6553.5 km/h (4072 mph) |
Vehicle stopped: 0.0 km/h (0 mph) | When driving at constant speed: No large fluctuations |
| Tester Display |
|---|
| Vehicle Speed |
Read the Data List according to the display on the GTS.
Reference km/h: (w/o Rear Occupant Detection Sensor)
| GTS Indication (km/h) | Acceptable Range (km/h) |
|---|---|
| 20 | 21.0 to 25.0 |
| 40 | 42.0 to 46.0 |
| 60 | 63.0 to 67.0 |
| 80 | 84.0 to 88.0 |
| 100 | 104.0 to 108.0 |
| 120 | 125.0 to 130.0 |
| 140 | 146.0 to 151.0 |
| 160 | 167.0 to 173.0 |
| 180 | 187.0 to 194.0 |
| 200 | 208.0 to 215.0 |
| 220 | 229.0 to 238.0 |
| 240 | 249.0 to 257.0 |
| 260 | 270.0 to 298.0 |
Reference km/h: (w/ Rear Occupant Detection Sensor)
| GTS Indication (km/h) | Acceptable Range (km/h) |
|---|---|
| 20 | 20.4 to 22.4 |
| 40 | 40.7 to 42.7 |
| 60 | 61.1 to 63.1 |
| 80 | 81.5 to 83.5 |
| 100 | 101.9 to 103.9 |
| 120 | 122.2 to 124.2 |
| 140 | 142.6 to 144.6 |
| 160 | 163.0 to 165.0 |
| 180 | 183.4 to 185.4 |
| 200 | 203.7 to 205.7 |
| 220 | 224.1 to 228.1 |
| 240 | 244.5 to 248.5 |
Speedometer reading is within the acceptable range at each vehicle speed.
Check tachometer
Warm up the engine.
Put the engine in inspection mode (maintenance mode).
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE
Enter the following menus: Powertrain / Engine / Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Engine Speed | Engine speed | Min.: 0 rpm, Max.: 16383 rpm |
for V35A-FTS:
600 to 800 rpm: Idling (shift lever in P, engine warmed up and A/C off)
for 1GR-FE:
550 to 700 rpm: Idling (shift lever in N, engine warmed up and A/C off) |
- |
Read the Data List according to the display on the GTS.
| GTS Indication (rpm) | Acceptable Range (rpm) Data in ( ) is for Reference |
|---|---|
| 700 | 630 to 770 |
| 1000 | (900 to 1100) |
| 2000 | (1850 to 2150) |
| 3000 | 2800 to 3200 |
| 4000 | (3800 to 4200) |
| 5000 | 4800 to 5200 |
| 6000 | (5750 to 6250) |
| 7000* | 6700 to 7300 |
*: for 4.2 Inch Multi-information Display
Tachometer reading is within the acceptable range at each engine speed.
Check LED illumination (LED check)
Check the illumination function of the warning or indicator lights listed below when turning the ignition switch to ON.
| Indicator/Warning Light | Switch Condition | Specified Condition |
|---|---|---|
| Malfunction indicator lamp | Ignition switch off → ON |
·
Illuminates when the ignition switch is turned to ON
·
Turns off when engine started |
| PKSB OFF indicator light*1 | Ignition switch off → ON | Comes on for 3 seconds |
| Automatic high beam indicator light*2 | ||
| Stop and start OFF indicator light*3 | ||
| Brake warning light | ||
| ABS warning light | ||
| Slip indicator light | ||
| VSC OFF indicator light | ||
| Eco driving indicator light | ||
| PCS OFF warning light*4 | ||
| RCTA OFF indicator light*5 | ||
| BSM OFF indicator light*6 | ||
| Brake hold standby indicator light | ||
| Brake hold operated indicator light | ||
| PPS warning light | ||
| SRS warning light | Ignition switch off → ON | Comes on for 6 seconds |
*1: w/ Parking Support Brake System
*2: w/ Automatic High Beam System
*3: w/ Stop and Start System
*4: w/ Pre-collision System
*5: w/ RCTA
*6: w/ Blind Spot Monitor System