When replacing the starter assembly, it is necessary to replace the ST NO. 1 relay as well.
28100 1.INSPECT STARTER ASSEMBLY
Do not use a thin cable to perform the inspection.
If a thin cable is used, the large electric current passing through the cable could cause it to overheat and catch fire, possibly resulting in injuries.
Perform each of the following tests within 3 to 5 seconds to prevent the coil from burning out.
Perform a no-load performance test.
| *a | Terminal 50 |
| *b | Starter Body |
|
Moves Outward |
Connect the positive (+) lead to terminal 50.
Connect the negative (-) lead to the starter body and check that the clutch pinion gear moves outward.
If the positive (+) and negative (-) leads are connected incorrectly, the IC inside of the starter inrush current reduction relay will be damaged. Be sure to connect them correctly.
If the result is not as specified, replace the starter assembly.
| *a | Terminal 50 |
| *b | Starter Body |
|
Disconnect |
|
Moves Inward |
With the clutch pinion gear in the outward position, disconnect the negative (-) lead and check that the clutch pinion gear returns inward.
If the result is not as specified, replace the starter assembly.
Hold the starter assembly in a vise between aluminum plates.
Ensure that the starter assembly is secured in the vise to prevent it from falling out.
Connect the battery and an ammeter (AC/DC 400A probe) to the starter assembly as shown in the illustration.
| *a | Terminal 50 | *b | Terminal 30 |
| *c | Starter Body | *d | AC/DC 400 A Probe |
Connect terminal SL2 and measure the current after the ammeter (AC/DC 400A probe) reading has stabilized.
130 A or less at 11.5 V
If the result is not as specified, repair or replace the starter assembly.