To prevent injury due to contact with an operating fan and generator V belt or cooling fan, keep your hands and clothing away from the fan and generator V belt and cooling fans when working in the engine compartment with the engine running.
16361A 1.INSPECT FAN AND GENERATOR V BELT
Check the fan and generator V belt for wear, cracks or other signs of damage.
If any of the following defects is found, replace the fan and generator V belt.
The fan and generator V belt is cracked.
The fan and generator V belt is worn to the extent that the cords are exposed.
The fan and generator V belt has chunks missing from the ribs.
| *a | CORRECT |
| *b | INCORRECT |
Check that the fan and generator V belt fits properly in the ribbed grooves.
Do not pour oil in the V-ribbed belt tensioner assembly while there is abnormal fan and generator V belt noise.
Check by hand to confirm that the fan and generator V belt has not slipped out of the grooves on the bottom of the pulley. If it has slipped out, replace the fan and generator V belt. Install a new fan and generator V belt correctly.
88359 2.INSPECT VISCOUS HEATER V BELT (w/ Viscous Heater)
Check the viscous heater V belt for wear, cracks or other signs of damage.
If any of the following defects is found, replace the viscous heater V belt.
The viscous heater V belt is cracked.
The viscous heater V belt is worn out to the extent that the cords are exposed.
The viscous heater V belt has chunks missing from the ribs.
| *a | CORRECT |
| *b | INCORRECT |
Check that the viscous heater V belt fits properly in the ribbed grooves.
Check with your hand to confirm that the viscous heater V belt has not slipped out of the grooves on the bottom of the pulley. If it has slipped out, replace the viscous heater V belt. Install a new viscous heater V belt correctly.
Inspect the viscous heater V belt tension or deflection value.
Check and adjust the viscous heater V belt when engine is cold.
Check the viscous heater V belt tension at the specified point.
Perform the V belt tension and deflection value check after idling the engine for a few minutes. After this, rotate the crankshaft pulley 5 times and adjust to the middle of the range of values given for "New belt".
With the exception of new belts, when reinstalling a belt used for 5 minutes or more, adjust to the middle of the range of values given for "Used belt".
Using a belt tension gauge, check the viscous heater V belt tension.
| Item | Condition | Specified Condition |
|---|---|---|
| New belt | Crankshaft pulley after 2 rotations | 550 to 800 N (56 to 82 kgf, 123.6 to 179.8 lbf) |
| Used belt | Crankshaft pulley after 2 rotations | 300 to 500 N (31 to 51 kgf, 67.4 to 112.4 lbf) |
16620D 3.INSPECT V-RIBBED BELT TENSIONER ASSEMBLY
Check that nothing is caught in the V-ribbed belt tensioner assembly by turning it clockwise and counterclockwise.
If a malfunction exists, replace the V-ribbed belt tensioner assembly.
Turn the pulley, and check that the tensioner bearing moves smoothly and quietly.
If a malfunction exists, replace the V-ribbed belt tensioner assembly.