To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
89481B 1.INSPECT DIFFERENTIAL PRESSURE SENSOR
Remove the No. 1 engine under cover assembly.
Remove the No. 2 engine under cover assembly.
Slide the clamp and disconnect the air hose from the differential pressure sensor.
Install SST to the differential pressure sensor.
Turn the ignition switch on.
Using GTS, read the data list.
| Tester Display |
|---|
| Particulate Filter Differential Pressure Bank 1 |
| *a | Pressure |
Apply pressure to the differential pressure sensor.
Perform the inspection within the range of 0 to 98 kPa (0 to 1.0 kgf/cm2, 0 to 14.2 psi).
Approximately the same pressure as the applied pressure is indicated on the GTS.
Restrore to the original state.