MAINTENANCE PRECAUTION
Moving and storing the turbocharger sub-assembly
Do not hold the actuator or control rod.
When storing the turbocharger sub-assembly, do not store the assembly with the actuator facing down.
Make sure foreign matter does not enter the intake and exhaust ports and oil passage.
When installing the turbocharger sub-assembly
| *1 | Turbocharger Stay |
| *a | Sludge |
If replacing the turbocharger sub-assembly, check for deposits in the turbocharger stay.
If necessary, replace the turbocharger stay.
If replacing the turbocharger sub-assembly, add 20 cc (1.2 cu. in.) of fresh oil into the turbocharger sub-assembly oil inlet hole and turn the turbine wheel by hand to spread oil over the bearing.
| *1 | Turbocharger Sub-assembly | *2 | No. 2 Turbocharger Sub-assembly |
| *a | Turbocharger Sub-assembly Oil Inlet Hole | - | - |
Pour the oil into the smaller oil hole on the oil inlet side.