23300 1.INSPECT FUEL FILTER ASSEMBLY
| *a | Component without harness connected (Fuel Filter Assembly) |
Inspect the level warning switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(V16)Location & Routingewd_type=routing;type=c;code=V16 Click Connector(V16)Body>Differential Wire / Frame Wire>Level Warning Switch (Fuel Filter Assembly)ewd_type=component;type=c;code=V16;pinno=1,2 |
||
| V16-1 - V16-2 | Float at upper end position | Below 1 Ω |
| V16-1 - V16-2 | Float at lower end position | 10 kΩ or higher |
If the result is not as specified, replace the fuel filter assembly.
Inspect the clogging switch.
| *a | Component without harness connected (Fuel Filter Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(V17)Location & Routingewd_type=routing;type=c;code=V17 Click Connector(V17)Body>Differential Wire / Frame Wire>Vacuum Switch (Fuel Filter Assembly)ewd_type=component;type=c;code=V17;pinno=1,2 |
||
| V17-1(FCHK) - V17-2(E) | 20°C (68°F) | Below 3 Ω |
If the result is not as specified, replace the fuel filter assembly.
Inspect the heater.
| *a | Component without harness connected (Fuel Filter Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(V15)Location & Routingewd_type=routing;type=c;code=V15 Click Connector(V15)Body>Differential Wire / Frame Wire>Fuel Heater (Fuel Filter Assembly)ewd_type=component;type=c;code=V15;pinno=1,2 |
||
| V15-1(H+) - V15-2(H-) | 20°C (68°F) | 0.1 to 0.9 Ω |
If the result is not as specified, replace the fuel filter assembly.